
Section 5
GLOSSARY
Blank voltage (Main Menu Startup screen)
or
Polarity indicator (positive or negative voltage)
or
Scroll up or down list
A Refers to Automatic test
Adjust Displays while plate voltage is being adjusted to 1050 volts
Auto Seq See The Set-up Menu (Page 6)
AutoShtDwn See The Set-up Menu (Page 6)
Bal See The Set-up Menu (Page 6)
Bal dur See The Set-up Menu (Page 6)
C Celsius temperature
Chrg Indicates that the plate is being charged
ClrData See The Set-up Menu (Page 6)
Decay Indicates that the plate voltage is decaying
Delay Pause between auto tests
Enter When displayed, press ENTER to view or modify the present option
Err Decay>200sec Voltage did not decay to 100
Exit See The Set-up Menu (Page 6)
Fac. Deflt See The Set-up Menu (Page 6)
M Refers to Manual test
MDA Average times for Manual Decay tests
MemUsed Shows percentage of Automatic and Manual memory currently in use
Min Minutes (see AutoShtDwn and The Set-up Menu (Page 6)
Mn Min voltage in balance tests
Mx Max voltage in balance tests
MnB Balance results for Manual test n where n is test number
Mn+ or Mn
Decay time for Manual test n where n is test number (1-0)
MnTH Temperature and Humidity data for Manual decay test n
NAD Average Decay times for automatic sequence N
NBa Balance results for automatic sequence N
NnD+ or NnD
Decay times for automatic test number n (1-3) in test sequence N (1-
0)
NTH Temperature and Humidity for automatic sequence N
Null Results from holding any primary key too long — reverts to main
display
Off If ON/OFF key is released while Off is displayed, the unit will be shut
off
ON=EXIT Press ‘ON’ key to exit Set-up menu
RH Relative Humidity in percent
RvwData See The Set-up Menu (Page 6)
Sec or s Time in seconds
Set-Up Release key to enter Set-Up mode
Tst dly See The Set-up Menu (Page 6)
V Volts
Ver Firmware version
Zero Indicates that the instrument is being autozeroed
Comentarios a estos manuales